ARGOX X 2000V PPLB DRIVER DOWNLOAD

Troubleshooting Normally, if the printer is in not working properly, the “READY” LED blinks continuously, and printing and communication between the host and printer stops. Repeat if necessary until the cotton is clean after it is passed over the head. Without media calibration, printer may detect labels with less accuracy, especially for small labels less than 1. It is to control cut actions of guillotine cutter. Blinking Green Amber The printer waits for printer ready.

Uploader: Moogugrel
Date Added: 18 January 2008
File Size: 20.58 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 1721
Price: Free* [*Free Regsitration Required]

It decides which setting method – by command or by LCD panel, is prior. The ribbon shaft has its user-friendly feature to allow users to adjust the tension of ribbon shaft by rotating the knob. Figure 3 3 Ribbon Supply Spindle 14 4.

Seagull Argox X-2000v PPLB Free Driver Download (Official)

Blinking Green Amber The printer waits for printer ready. Internal character sets standard 5 alpha-numeric fonts with height from 0. If you use direct thermal, set with panel, Windows driver or command. Then release the buttons to enter settings.

Related questions Dear Sir, Can i connect directly to Argox ppla printer using php? If the ribbon is wrinkled at ribbon supply, rotate clockwise control knob of ribbon supply, to increase ribbon tension at ribbon supply and further improve ribbon wrinkle. Press and hold the FEED button arbox turning on the power. A multilingual LCD display on the front panel makes installation, configuration, and operation simple and convenient. The printer will then feed the labels through the cutter automatically.

  INTF2 USB DRIVER

Argox X |

Argkx off ppln printer before cleaning. If the tension is too little at ribbon pickup, ribbon will not move smoothly, and needs control knob to rotate clockwise to increase tension. W mm x H mm x D mm. Water or spit should be kept away in case of corrosion on heating elements. Peel-off mode peels backing material away from the label as it prints. Centronics allows a much higher communication speed than serial.

Button x 3 Feed Config. Make a form for the keyboard. Please note, as shown in Fig. Steps to adjust are as below: Make sure the Ribbon Bracket is at its lowest position first; then tight up the screws by rotating clockwise.

If the data has been sent, but there is no output from the printer. Open the left cover of printer. Pin 9 is reserved for a KDU keyboard device unit. Loose the three screws from Tear-off Bracket and then remove Tear Bracket.

The printer feeds inches of blank labels. Click Cancel and do not install the driver using this wizard. pplh

  AMB01US VISTA DRIVER DOWNLOAD

Printer finds the first label gap when print head is closed. For labels with gaps, label sensor can be positioned wherever media locates.

Return the outside media guide, close the bracket, and hook the head latch. If the problem persists, replace the print head. Illustrations are provided to help you quickly become familiar with the printer.

Courier font with different symbol sets. Refer to the following command sample. Check for any traces of black coloring or adhesive on the cotton after cleaning.